Hardwood Floor Repair & Board Replacement in Scottsdale, AZ

Hardwood floor repair and board replacement only lasts if the cause is fixed first. A cupped board by the dishwasher, a row of planks lifting near a patio door, or a hollow-sounding area in the middle of a room each point to something different: a leak, outside water, slab moisture, or adhesive that never bonded. We look for the reason, then repair the floor.

Common problems in desert homes

• Gaps between boards: dry air shrinks the wood. Small seasonal gaps that close in the monsoon are normal; wide, permanent gaps may need boards replaced or filler strips.
• Cupping: board edges higher than centers, caused by more moisture below than above. In slab homes, look for plumbing or irrigation leaks, wet slabs, or monsoon water at doors.
• Buckling or tenting: the floor pushed up because it had no room to expand, often after a humid stretch.
• Hollow spots and loose planks: glue-down planks that lost their bond, usually from slab moisture or an uneven surface.
• Scratches, dents and pet damage: surface wear that may need a recoat, a board swap, or a refinish of the whole room.

Water damage

Water from a refrigerator line, a slab leak, a sink or a sliding door is the most common reason boards must come out. Fixr notes that a plumbing consultation to find a leak can run $150 to $400, and the leak needs to be stopped and the slab dried before new boards go in. We take moisture readings across the area so we replace all the affected boards, not just the ones that look bad.

Weaving in new boards

Replacement boards are cut in so their ends stagger with the existing floor, rather than in a straight patch that shows. For solid and engineered floors, we match species, width, and thickness, and look for the same product when possible. Older or discontinued floors can be matched with leftover boxes, boards from a closet, or close substitutes. New wood may look different until it is finished, and full color blending can take a refinish of the room.

Re-bonding loose planks

Some hollow glue-down areas can be fixed by injecting adhesive through small holes, then filling and touching up the holes. Larger or badly loose areas need the planks pulled, the old adhesive scraped, the slab checked and new adhesive laid. We tell you which approach fits after tapping out the area and checking slab moisture.

Repair or replace?

If most of the floor is damaged or the product is no longer made, replacement may cost less than patching. We give you the cost of both when it is a close call.